Please give me some help, what I can do. Then, press the Start button again. My ASKO is the same right now. Check whether dishwasher inlet hose is connected to a pressure limiting valve (some pressure limiting valves may restrict the supply of water to the dishwasher). The only way to stop it is to switch it off . Not sure what is going on. I do not have an error code display on the front panel. In case you find water in the tray under the dishwasher, check the motor housing, the tub, the drain hose or the door for any damages or clogs. See if the tray under the dishwasher is full of water, Check the float, this float stops the water flow, be sure it is not blocked, If there is no leak into the dishwasher pan then check that the draining hose under the sink is not leaking, Be sure the drain hose goes up to the top and under the counter top and down to the drain. Fault F40 indicates that the inlet valve has been letting water through when it should have been closed. Disconnect the power to the unit 2. Theres a number of possible causes and relevant actions to take. Christchurch. I managed to do a flush with a rinse cycle followed by an empty full cycle with a dishwasher cleaner, but the moment I try do a load with dishes then I get the F11 error. Selected temperature not reached in 90 minutes, Check load for out of balance Redistribute load and restart. COMMUNICATION Ul AND PMCU Error in Ul and PMCU communication. The open door error keeps flashing (horizontaLines ) but door isnt open or blocked? Remove the water 4. thank you, Hi there my dishwasher seems to rotate between time and Broken lines all adjustments seems to work but reverts back to rotating between time and broken lines ,any ideas please. If the wiring seems to be correct, your thermistor might be malfunctioning. Heating element burned out. CODE:F4 PROBLEM:Fault with water fill (only on machines with level-controlled fill) Note: Lights blinking, pump running and controls dead indicates an over fill fault. Copyright protected content owner: ReadyToDIY.com and was initially posted on 2022-05-17. CODE: E1 PROBLEM: THERMISTOR ERROR Temperature sensor error. Any images or third-party logos belong to their respective copyright holder and used for informational purposes.
The Future starts Here